Temperatures for July are running about one degree above average, according to the National Weather Service.

Temperatures for July are running about one degree above average, according to the National Weather Service. Welcome to our new and improved comments, which are for subscribers only. This is a test to see whether we can improve the experience for you. You do not need a Facebook profile to participate. You will need to register before adding a comment. Typed comments will be lost if you are not logged in. Please be polite. It’s OK to disagree with someone’s ideas, but personal attacks, insults, threats, hate speech, advocating violence and other violations can result in a ban. If you see comments in violation of our community guidelines, please report them. Left, Cyra Swanson, 3, splashes in a fountain at the Dr. Martin Luther King, Jr. park pool, Saturday, July 30, 2016. (Photo: Jenna Watson/IndyStar)Buy Photo The state’s hottest recorded temperature was just that on July 14, 1936, according to the National Weather Service. Temperatures were forecasted in the 90s, but climbed much higher than that thanks to the heat index, which factors in temperature and humidity to create a “feels like” temperature. We’re only running about one degree above...

‘); //–> <!– window.dataLayer = window.dataLayer || []; function gtag(){dataLayer.push(arguments);} gtag('js', new Date()); gtag('config', 'UA-1658554-11', {

‘); //–> com.realmagnet.MagnetLeads.init(‘OrfhmQgk6sGIKGvE9vw’); com.realmagnet.MagnetLeads.visitPage(); The spindle is the heart of the machine. The following are some troubleshooting tips to ensure your machine is running at its optimum performance. The spindle is running backward. This is common with 3-phase motors with terminal blocks. Switch any two power leads and the spindle will run in the proper direction. Spindle jerks or vibrates badly on startup and performs poorly. This is an indication of single phasing. Verify the connections at the spindle, VFD, and any connectors. If that doesn’t work, send it to an expert for motor diagnostics and repair. Getting an “over current” or similar fault on the VFD. Verify the connections at the spindle, VFD, and ensure any connectors are clean, tight, and secure. Verify the VFD parameter settings.    If the winding is shorted or insulation is broken down, send it to an authorized dealer for evaluation and repair. I just replaced my VFD and it keeps tripping out. Start by verifying that these basic drive parameters (link to Yaskawa / Delta drive settings) are set according to your spindle. Note: This only...